Cessna 208B Handling And Performance Mod
Increased Power and adjusted drag/lift to better match the real power of this aircraft.
I also changed the torque behavior vs. altitude, so that torque slowly decreases and not increases.
I adjusted torque effect on ground roll too.
Changed from 2 flap setting config (15° & 30°) to a 3 flap setting config (10°, 20° & 30°). But there are only two animated stages of the flaps, so in the outside view, you still only see the 2 standard settings. But in aerodynamics 3 settings are simulated and you feel them during flight.
Now you can take-off with 20°, retract from 20° to 10° @ around 85 KIAS and retract from 10° to Up @ around 95 KIAS.
Now you can perform short field take-offs nearly as you should be.
I found a POH for a 670+ Hp version. Aircraft in MS FS simulates a 850+ Hp version and can´t nearly perform as the POH of the 670+ Hp version states.
Also there should be 3 flap settings available. So I changed that.
But I am only limited in what i can do, because I am not a pro and SDK documentary is very limited. I still havent figured out how to changed increasing fuel consumption to a decreasing fuel consumption with increasing altitude. But I capped fuel consumption on a lower value, to compensate a bit.
So the mod doesn´t provide an exact remodel of the 208B behavior, but it now feels way better and more powerfull than vanilla. I will continue to iterate on the values, but this is very time consuming and as i stated I only have the values for the 670+ Hp version.
